Max Knives PBF-5 — Clip Point Butterfly Knife, D2 Steel, Dished-Disc Handle
- Blade length108mm
- Blade materialD2 tool steel
- Overall length245mm
- Handle materialAnodised aluminium
- Weight116g
The PBF-5 is known by the dished discs milled along its arms, a circular pattern cut into the anodized aluminium. A 108 mm clip point blade in D2 tool steel, 142 mm closed, 245 mm open.
Overview
On the PBF-5, the black anodized aluminium is hollowed by a run of dished discs spread along both arms. The pattern is milled from the solid of the integral handle rather than applied: the circles sit slightly recessed, and the finger counts them as the arms turn on their two pivots around the blade. The blade itself, in D2 tool steel, takes a 108 mm clip point profile with a light satin finish. 142 mm closed, 245 mm open.
The disc pattern, milled from the solid
Every handle design in the series has its own way of speaking to the finger. The dished discs of the PBF-5 form a run of circular hollows along the length of the arms, obtained by machining directly into the anodized aluminium with no applied part: the integral construction stays in one piece. This is the third of the four handles on the grid, after the V ridge of the PBF-1 and 2 and the skeletonised handle of the PBF-3 and 4, and before the angled grooves of the PBF-7 and 8. Its tanto twin is the PBF-6.
Technical specifications
108 mm clip point blade in D2 tool steel, plain edge, 3 mm thick, light satin finish, D2 marking engraved at the ricasso beside the house logo. Black anodized aluminium handle of integral construction with dished machined discs, 12.50 mm thick, two exposed pivot screws. 142 mm closed, 245 mm open overall.
Care
The circular hollows hold a little dust: a pass with a dry cloth goes round them and a brush finishes the job. The blade is dried after each handling session and given a film of light oil, which suits D2 tool steel over time. Oil the two pivots as well to keep the rotation even, and retighten their screws if any play appears. Sharpening follows the continuous curve of the clip point through to the tip.
Legal notice for international buyers. Age-restricted item (18+). In France this is a Category D item: legal to sell but reserved for adults, with age verification at checkout. Carrying it in public without a legitimate reason is an offence in France and in most European countries. It is the buyer's responsibility to check the law that applies where the order is delivered before purchasing.
-
Blade materialD2 tool steel
-
Edge typePlain edge
-
Handle materialAnodised aluminium
-
Blade shapeClip point
-
Blade length108mm
-
Handle length142mm
-
Overall length245mm
-
Blade thickness3mm
-
Weapon categoryD
-
SaleNot for sale to minors
-
Weight116g
-
Blade length (range)100 to 130 mm
-
Overall length (range)200 to 250 mm
-
Blade thickness (range)3 to 4 mm
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent