Max Knives FP1801-211 — Large 260 mm Bowie, numbered piece No. 211
- Blade length150mm
- Blade material440C steel
- Overall length260mm
- Handle materialG10
Numbered piece No. 211 of the large FP1801 Bowie: 260 mm overall, the longest knife Fred Perrin has drawn for Max Knives, with a 150 mm 440C stone wash blade and G10 handle.
Overview
No. 211 is a numbered piece of the FP1801, the largest knife in the Fred Perrin range at Max Knives. Two hundred and sixty millimetres overall, of which 150 mm is Bowie blade in 440C and 95 mm is G10 handle: this is a format held in a full hand, not one that slips into a pocket. The blade carries a stone wash finish and measures 5 mm at the spine. The kydex sheath supplied takes a multi-position tecklock attachment, which starts to matter as soon as a knife reaches this length.
What a 260 mm length changes
A 260 mm knife does not handle like a pocket model, and that is exactly its appeal. The 95 mm handle lets four fingers settle without crowding, which changes everything once a movement repeats. Ahead of it, 150 mm of edge takes a material in a single pass where a short blade forces you to start again. Mass distributes differently too: over that much leverage the tool follows the movement instead of asking for it. Carry is planned accordingly, hence the moulded sheath and its adjustable mount, which decide where the knife sits on the belt.
Technical specifications
Fixed blade, numbered piece No. 211. Overall length 260 mm: a 150 mm blade and a 95 mm handle. Blade in 440C steel, Bowie shape with a plain edge and a stone wash finish, 5 mm at the spine. G10 handle. The piece comes with its kydex sheath and a multi-position tecklock attachment. Drawn by Fred Perrin and produced by Max Knives. The FP1903 takes up the same geometry over 179 mm overall.
Care
A long blade is dried along its whole length, from heel to point, with attention where the clip point hollows out. Rinse under clean water after use, dry with a cloth, then oil lightly if the knife is to sit stored for several weeks. The stone wash finish calls for neither paste nor polish: a soft cloth, and that is all. On the carry side, check the tecklock screws and empty the kydex sheath of dust before the blade goes back in.
Legal notice for international buyers. Carrying it in public without a legitimate reason is an offence in France and in most European countries. It is the buyer's responsibility to check the law that applies where the order is delivered before purchasing.
-
Blade material440C steel
-
Edge typePlain edge
-
Handle materialG10
-
Blade shapeBowie
-
Blade length150mm
-
Handle length95mm
-
Overall length260mm
-
Blade thickness5mm
-
Blade finishStonewash
-
SheathKydex sheath included
-
Blade length (range)Over 130 mm
-
Overall length (range)Over 250 mm
-
Blade thickness (range)Over 4 mm
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent